Proctor-Silex 840091400 - Manual (Page 3)

5
1. Unplug iron. Using a cup, slowly pour 4 ounces ( 1 ⁄ 2 cup) of
tap water into water tank opening. Plug iron into outlet.
2. Set Adjustable Steam Switch to STEAM.
3. Turn Temperature Control Dial to desired fabric setting in
steam range. Allow two minutes for the iron to reach desired
temperature.
Water: Please use ordinary tap water. If you have extremely
hard water, alternate between tap water and distilled water
for use in the iron.
To Steam Iron
To Dry Iron
1. Set Adjustable Steam Switch to 0 or empty water tank.
2. Turn Temperature Control Dial to desired temperature.
Allow two minutes for iron to reach desired temperature.
4
Features (not all features on all models)
Adjustable Steam Switch
This switch provides continuous steam
in the STEAM position. Push the
switch to 0 to change to dry iron.
Auto Shutoff Reset Button/Light
The light comes on when the iron is first
plugged in even if Temperature Control
Dial is set at Off. The light indicates that
the iron is plugged in. After one hour,
the iron will shut off and the light will
blink. Push the Reset Button to turn the
iron back on.
Power On Light
This light comes on when the iron is
plugged in and remains on until the iron
is unplugged. The light stays on even if
Temperature Control Dial is turned to Off.
Before First Use
• Steam vents should be cleaned before first use. Prepare
iron for steam ironing, then iron over an old cloth for a few
minutes while letting the iron steam.
• Many irons spit or sputter during the first few uses with
tap water. This happens as the steam chamber becomes
conditioned. This will stop after a few uses.
• During first use of the iron, it may appear to smoke. This
will stop and does not indicate a defect or hazard.
Reset
Button
Light
Power
Light