Philips MCD710 - Manual (Page 32)

32
English
Setting sleep/wake-up timer
Sleep timer setting
In power-on mode , the sleep setting enables
the system to switch to standby mode
automatically at a preset time.
1
In power-on mode, press SLEEP/TIMER on
the remote repeatedly to select a preset time.
➜ The selections are as follows (time in
minutes):
00
➜ 10 ➜ 20 ➜ 30 ➜ 40 ➜ 50 ➜ 60 ➜ 70
➜ 80 ➜ 90 ➜ 00
2
When you reach the desired length of time, stop
pressing SLEEP/TIMER.
➜ ” SLEEP” appears.
To deactivate the sleep timer
●
Press SLEEP/TIMER repeatedly until “00” is
displayed, or press STANDBY-ONB.
In standby mode, the timer setting enables the
system to switch on automatically at a set time.
Wake-up timer setting
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
1
Press and hold SLEEP/TIMER until the time
flashes on the display.
➜ ” TIME SET” scrolls. Then, the hour digits
flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
hours.
3
Press SLEEP/TIMER to confirm.
➜ The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
minutes.
Other Functions
5
Press SLEEP/TIMER to confirm the time
setting.
➜ ” OFF” flashes on the display screen.
6
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to select
“ON”.
➜ icon appears on the display screen.
To deactivate the timer
●
Select “OFF” at Step 6.
pg 001-040_MCD710_93_Eng 2007.8.29, 11:37 32