Cd player, Playing a cd, Selecting a different track – Philips AZ1022 User Manual
Page 7: Finding a passage within a track, Programming track num- bers
Playing a CD
•
This CD player plays Audio Discs including
CD-Recordables (CD-R) and CD-Rewritables
(CD-RW).
•
MP3, CD-ROM, CD-I, CDV,VCD, DVD or
computer CDs are not possible for playback.
IMPORTANT!
CDs encoded with copyright protection
technologies
by some record companies may
be unplayable by this product.
1
Adjust the Source selector to CD.
2
Open the CD door, and insert a CD with
the printed side facing up, then press the CD
door gently to close.
➜ Display shows --, and later the total
number of tracks. (
See 3)
3
Press
2/;
to start playback.
4
To pause playback, press
2/;
.
➜ Display:
2
flashes. (See 4)
5
To resume, press
2/;
again.
6
To stop CD playback, press
9.
Helpful hints:
CD play will also stop when:
–
you open the CD door;
–
you select TUNER or TAPE/ OFF sound
source;
–
the CD has reached the end.
Selecting a different track
•
Press
∞/ §
once or repeatedly until the
desired track number appears in the display.
•
In the pause/stop position, press
2/;
to start
playback.
Finding a passage within a
track
1
During playback, press and hold
∞
or
§
.
➜ The CD is played at high speed and with
reduced volume.
2
When you recognize the passage you want,
release
∞
or
§
to resume normal playback.
Helpful hints:
–
When your searching reaches
the end of the
last track, the CD goes to stop mode.
Programming track num-
bers
You may store up to 20 tracks in the desired
sequence. If you like, store any track more
than once.
1
In the stop position, press PROG to
activate programming.
➜ Display: PROG and 00 flash. (
See 5
)
2
Press
∞
or
§
to select your desired track
number.
3
Press PROG to store the desired track
number.
➜ Display: PROG and 00 flash for you to
program the next track..
4
Repeat steps 2 to 3 to select and store all
desired tracks in this way.
➜ If you attempt to store more than 20
tracks, no track can be selected and the
display shows -
--
-.
5
To play your program, press
2/;
.
Helpful hints :
–
When playback of your program comes
to the stop position, your set will return
to normal playback.To re-enter program
mode, press PROG in the stop position.
CD Player
AZ1022_Eng 6/18/08 17:42 Page 7