User manual – Philips FM02SW00 User Manual

Page 2

Note

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one

or more of the following measures:

•

reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

The shielded interface cable and connectors must be used in order

to comply with the limits for digital device pursuant to subpart B

of Part 15 of FCC rules.

Electric-, Magnetic- and Electromagnetic Fields (EMF)

Philips royal electronics manufactures and sells many products

targeted at consumers, which, like any electronic apparatus, in general

have the ability to emit and receive electro magnetic signals.

one of Philips’ leading Business Principles is to take all necessary

health and safety measures for our products, to comply with all

applicable legal requirements and to stay well within the emF

standards applicable at the time of producing products.

Philips is committed to develop, produce and market products that

cause no adverse health effects.

Philips confirms that if its products are handled properly for their

intended use, they are safe to use according to scientific evidence

available today.

Philips plays an active role in the development of international emF

and safety standards, enabling Philips to anticipate further

developments in standardization for early integration in its products.

Specifications are subject to change without prior notice. “Active

Crystals”, “Philips” and “Swarovski” are registered trademarks and

are the property of koninklijke Philips electronics N.V. (and/or their

This manual is related to the following products: