Precor ELECTRONIC CONSOLE 903 - Manual (Page 5)

page 5
Installing the Electronic Console
The handrail clamp can be used on either the 903 or 904
treadmill. However, the steps used to install the console
onto the clamp are slightly different depending on which
treadmill you have. Please refer to the steps that apply to
your treadmill.
903 Assembly Procedures
To install the 903 electronic console, take the following
steps:
1. Locate the handrail clamp in the box that accompanies the
electronic console’s box. Remove the long and short
screws from the handrail clamp using your fingers or a
Phillips head screwdriver. Set the screws aside. You can
discard the short screws since they are only used for
the 904 assembly.
Diagram 1
2. Place the handrail clamp around the mid-portion of the
handrail as shown in Diagram 1. Place a hand on
either side of the handrail clamp to gently pull it apart
so that you can slide it onto the handrail’s foam grip.
Important: Do not mount the clamp on the painted
surface of the handrails.