POSIFLEX Business Machines Cash Drawer CR400X - Manual (Page 3)

3
b). For CR4001/ 4101/ 4211/ 4002/ 4102/ 4212: CCBLA-196A with one 9PM and one
9PF connector.
c). For CR4003/ 4103/ 4213: CCBLA-089-1 with one 25PM and one 25PF connector.
d). For CR4004/ 4104/ 4214: The serial signal cable is already built on.
e). For CR4005/ 4105/ 4215/ CR4005-II/ 4105-II/ 4215-II: USB cable is already built on.
6. Power Source depend on model
a). For CR-4000/ 4100/ 4210: not applicable
b). For CR-4001/ 4101/ 4211/ 4002/ 4102/ 4212/ 4003/ 4103/ 4213/ 4005/ 4105/ 4215 /
CR4005-II / 4105 -II/ 4215-II: Power adapter 12VAC 1.5A
c). For CR4004/ 4104/ 4214: Power connector cable and I/O bracket plate.
INSTALLATION
CR4000 / 4100 / 4210 Connect the drawer to POS system/printer as shown below:
CR4001 / 4101 / 4211
1). Connect the drawer serial I/P port to the computer COM port. Connect the power
adapter output to the Power Input jack
2). No other RS232C devices should be connected to the serial O/P port.
3). Set position 3 of S2 to OFF and position 4 of S2 to ON. Please refer to rear panel
illustration.
CR4002 / 4102 / 4212
1). Connect the drawer serial I/P port to the computer COM port. Connect the power
adapter output to the Power Input jack.
2). Other RS232C device can be connected to the serial O/P port when needed as long as
the security code makes no influence to this RS232C device.
3). Set position 3 of S2 to ON and position 4 of S2 to OFF. Set S1 for security code to open
cash drawer. In normal practice, the security code is suggested to be a non-displayable
ASCII character, for example, a hexadecimal number between 01 to 1F. Please refer to
rear panel illustration below.
CR4003 / 4103 / 4213
1). Connect the drawer parallel I/P port to the computer LPT port. Connect the power
adapter output to the Power Input jack.
2). Other parallel device such as a printer can be connected to the parallel O/P port when
needed as long as the Security code makes no influence to this parallel device.
CASH DRAWER
With Printer Interface
8P Telephone Jack
8P Telephone Plug
6P Telephone Plug
Output to drawer
POS System or Printer
Ground
Rear View
Control signal input