ParaBody 216 - Manual (Page 3)

3
FIGURE 2
• Unscrew the WEIGHT STACK CABLE
from the 15 HOLE WEIGHT STACK
SHAFT as shown in FIGURE 2.
STEP 2:
WEIGHT
STACK PIN
WEIGHT STACK
CABLE
15 HOLE WEIGHT
STACK SHAFT
• Remove the WEIGHT STACK PIN from
the 15 HOLE WEIGHT STACK SHAFT as
shown.
• CAREFULLY remove or loosen bolts in the TOP BOOM
to allow the GUIDE RODS to be tilted. Refer to the GYM
ASSEMBLY INSTRUCTIONS .
FIGURE 3 STEP 3:
• Tilt the GUIDE RODS back and remove the SHAFT
COLLARS, HEAD PLATE ASSEMBLY, fifteen WEIGHT
PLATES, two WEIGHT STACK CUSHIONS, two 3/4”
WASHERS, and two WEIGHT STACK SPACERS as shown
in FIGURE 3. (NOTE: Please discard the two 3/4”
WASHERS, and the two WEIGHT STACK SPACERS.)
HEAD PLATE
SHAFT COLLAR
WEIGHT STACK SHAFT
BASE
WEIGHT PLATE
WEIGHT STACK CUSHION
3/4” WASHER
WEIGHT STACK
SPACER
GUIDE ROD