Pioneer DVR-3100 - Manual (Page 29)

Getting started 04
29
En
English
• If the recorder is connected to your TV using a SCART
cable and your TV supports Direct Recording, you
can use this to very simply start recording the TV
channel you’re currently watching. See
Direct
recording from TV on page 48 for detailed instructions.
5 Press ì REC to start recording.
• By default, the recording will be in SP (standard play)
mode, which will give you around 2 hours of
recording from a blank DVD disc.
• You can pause recording by pressing PAUSE .
Press ì REC or PAUSE again to restart recording.
6 When you want to stop recording, press
STOP REC.
Playing back your recording
The TV program you just recorded should be on the DVD
disc as a single title with one or more chapters.
• Press PLAY to start playback.
If you want to stop playback before the end of the
recording, press
STOP .
Using the built-in TV tuner
Changing TV channels
When no disc is playing, you can change TV channels in
three different ways:
• CHANNEL +/– buttons on the remote
• Number buttons on the remote – For example, to
select channel 4, press 4 then ENTER ; for channel 34,
press 3 , 4 , ENTER .
• SMART JOG on the front panel
Note
• Channel presets are numbered 1–99.
• You can’t change TV channels during playback or
recording, or while in recording standby.
Changing audio channels
You can change the audio channel of the broadcast or
external input signal.
• Press AUDIO to change the audio.
The current audio channel is displayed on-screen.
• If the NICAM audio setting (see NICAM Select on
page 81) is set to NICAM and you are watching a
NICAM broadcast, you can switch between NICAM
and Regular (non-NICAM) audio.
• If the NICAM broadcast is bilingual, you can also
select the language.
You can also select the language for a non-NICAM bilingual
broadcast.
• When watching a recording made from an external
input with Bilingual recording selected (see External
Audio on page 81), you can switch the audio channel
between left ( L ), right ( R ) or both ( L+R ).
Note
• If a Video mode disc is loaded, or if the recording
mode is FINE / MN32 , only one channel of a bilingual
broadcast is recorded. In this case, decide which
language you want to record before recording by
setting the Bilingual Recording setting (see
Bilingual
Recording on page 82).
ENTER
CHANNEL
AUDIO
NICAM
Regular
NICAM A NICAM B
Regular NICAM A+B
A (L) B (R)
A + B (L+R)
L R
L+R
DVR-03_EU.book 29 ページ ２００３年７月２８日 月曜日 午後７時１９分