Philips REM400 - Manual (Page 13)

13
QUICK FEATURES SETUP GUIDE (continued)
Press component key
to be moved once
(e.g.,VCR).
Press SET
until Red Light
blinks twice;
release SET.
x 2
3
Press component key
to be reassigned once
(e.g., AUD). Red Light will
blink twice. Reassigned key is
now ready for programming.
4 1
Enter 9-9-2;
the Red Light
will blink twice.
x 2
2
Device Re-Assignment (e.g., AUD Key Becomes Secondary VCR Key)
Press SET
until Red Light
blinks twice;
release SET.
x 2
1
Press SET
until Red Light
blinks twice;
release SET.
x 2
5
Enter 9-9-5;
the Red Light
will blink twice.
Press FC1 or
FC2 once.
or
x 2
2 3
Press component
key that controls
channels once (e.g.,
CBL). Then enter
channel # (e.g. 7-1)*.
4
* NOTE: If over 100 channels, enter 0-7-1.
Programming The FC Keys (See Page 9 For Further Instructions)
Press component
key once
(e.g., TV).
Press an L key once
where new feature
is to be learned;
the Red Light will
blink rapidly.
Place remote controls
2" apart; on original one,
press and hold key to be
learned until Red Light on
DSS unit blinks twice.
To learn functions
onto other L keys (or
if Red Light does not
blink twice in step 5),
repeat steps 1~5.
Press SET
until Red Light
blinks twice;
release SET.
x 2
1 2 3 4
Enter 9-7-5;
the Red Light
will blink twice.
x 2
To lock in new feature,
press SET until
Red Light blinks twice;
then release SET.
x 2
5 6 7
2"
Programming The L1~L3 Keys (See Page 8 For Further Instructions)
REM400 Manual Engl 12/28/99 12:01 PM Page 13