Porter-Cable Double Insulated 10" Bench Top Table Saw 38239 - Manual (Page 7)

7
ASSEMBLY
BLADE RAISING AND
LOWERING HANDWHEEL
Insert the 1-3/4" screw (D) Fig. 4, through handle (E).
Assemble handle (E) to handwheel (A) by threading
screw (D) clockwise into handwheel as shown in Fig. 5.
Handle (E) should rotate freely on screw (D).
Fig. 4
Fig. 5
BLADE GUARD AND
SPREADER ASSEMBLY
1. DISCONNECT MACHINE FROM
POWER SOURCE.
2. THE BLADE GUARD AND SPREADER
ASSEMBLY MUST BE PROPERLY ALIGNED TO THE
SAW BLADE IN ORDER TO HELP PREVENT
KICKBACK.
3. Position the blade 90 degrees to the table and lock
in place.
4. Insert spreader end (A) Fig. 6, of blade guard into
anchor block (B). Push spreader (A) down into holder
until you hear a click, indicating that the spreader is
secured. NOTE: It is important that the spreader (A) be
in the vertical position and pushed straight down into the
spreader anchor block (B) during the assembly
procedure.
5. Fig. 7 illustrates the blade guard in place.
Fig. 6
Fig. 7
D
E
D
A
E
A
B
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
T H E M A C H I N E I S C O M P L E T E LY A S S E M B L E D A N D Y O U R E A D A N D U N D E R S TA N D T H E E N T I R E
INSTRUCTION MANUAL.