Pioneer DVR-545H-S - Manual (Page 143)

The Initial Setup menu 16
143
En
Audio Output Auto • Dolby Digital, MPEG and DTS sources are output as
a bitstream signal. However, depending on the
Audio Out setting, number of audio channels, and
the HDMI-connected device, Linear PCM audio may
be output.
PCM All audio signals are converted to Linear PCM
(except DTS).
Bitstream Priority Select if the connected device is compatible with
bitstream audio.
This setting is not available when a DVI device is connected .
Video Priority Mode HDMI • Select for high quality picture output on a connected
HDMI display. However, on this setting the YNR and
Detail picture quality settings are not effective for
analog video, and component video will be set to
interlaced.
Component Select if you want the YNR and Detail picture quality
settings to be effective for both HDMI and analog
video output, or if
Component Video Out is set to
Progressive while an HDMI display is connected
(page 135).
When watching video on an HDMI display, use the
HDMI setting.
Options
On Screen Display On • The recorder displays operation displays ( Stop , Play ,
etc.) on-screen.
Off Switches off the on-screen operation displays.
Front Panel Display On • The time is shown in the front panel display when the
recorder is in standby.
Off The front panel display is switched off in standby
(although it still lights dimly when setting a timer
recording).
Remote Control
Mode Recorder 1–3
(default: Recorder 1)
If you are using more than one recorder in the same
room, set them to different IDs. This setting sets the
recorder ID; to change the remote controller ID,
press and hold
RETURN then press 1 , 2 or 3 to set.
The remote will only control a recorder with the same
ID.
Setting Options Explanation
DVR645H_WY_EN.book 143 ページ ２００６年７月５日 水曜日 午前１０時２５分