Pioneer DEH-P4400 - Manual (Page 32)

07
Section
En 32
Initial Settings
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
1 FUNCTION display
Shows the function status.
1 Press SOURCE and hold until the unit turns
off.
2 Press FUNCTION and hold until TIME
appears in the display.
3 Press FUNCTION to select one of the initial
settings.
Press
FUNCTION repeatedly to switch between
the following settings:
TIME — WARN — AUX — DIMMER — FRT+REAR
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
BAND/ESC .
• You can also cancel initial settings by holding
down
FUNCTION until the unit turns off.
Setting the time
This is used to set the time on the unit’s clock
display.
1 Press FUNCTION to select the time.
Press FUNCTION until the time appears in the
display.
2 Select the portion of the time display you
wish to set with
2/3.
Pressing
2/3 will select a portion of the clock
display:
HOUR — MINUTE
As you select portions of the clock display the
portion selected will blink.
3 Select the correct time with
5/∞.
Pressing
5 will increase the selected hour or
minute. Pressing
∞ will decrease the selected
hour or minute.
1