ProForm 630DS 831.299253 - Manual (Page 7)

6. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet
from damage, place a mat under the treadmill.
4
3. Locate the plastic tie in the post on the left Upright (82).
Hold a Handrail Extension (85) in the position shown.
Insert the plastic tie into the Handrail Extension as you
insert the Handrail Extension into the post. Attach the
Handrail Extension with three short Screws (76). Note: The
plastic tie is tied to the Pulse Wire (125). Do not dam-
age the Pulse Wire. The Pulse Wire is used with the
optional chest pulse sensor (see page 18).
Slide a Handrail Foam Grip (110) onto the Handrail
Extension (85). If it is difficult to slide on the Foam Grip,
place a small amount of warm water and dish soap in the
Foam Grip. There may be one or two holes in the bottom
of the Foam Grip. Press a Plastic Fastener (47) into each
hole.
Attach the other Handrail Extension and Handrail Foam
Grip to the right Upright (not shown). Note: There is not a
pulse wire in the right Upright.
4. Make sure that the Lock Knob Sleeve (111) is fully in-
serted into the left Upright (82).
Remove the Lock Knob (102) from the Lock Pin (115).
Make sure that the Lock Pin Collar (113) and the Spring
(112) are on the Lock Pin. Insert the Lock Pin into the left
Upright (82) and tighten the Lock Knob onto it.
76
82
110
47
76
Post
85
125
3
113
115
111
112
102
82
Plastic Tie
5. Refer to figure 5a. Look at the left Rear Foot (59) at the
back of the treadmill. If the left Rear Foot touches the
floor, go to step 6. If there is a space between the left
Rear Foot and the floor, follow the instructions below.
Hold the treadmill firmly with both hands, and raise the
treadmill to the storage position as described on page 19.
Refer to figure 5b. Using a phillips screwdriver, remove the
Screw (60), the Rear Foot (59) Rear Foot Spacer (11)
from the right side. Reattach the right Rear Foot with the
Screw. Hold the treadmill firmly with both hands, and
lower the treadmill as described on page 19.
Check the left Rear Foot again (not shown). If the left
Rear Foot is still off the floor, raise the treadmill and re-
move the left Rear Foot. Snap the Rear Foot Spacer
(120) onto the left Rear Foot and reattach the Rear Foot
and Spacer to the treadmill. Carefully lower the treadmill.
59
120
60
5a
5b
59
7