beautypg.com

Fabric setting chart, Caring for your iron – Proctor-Silex 17610 User Manual

Page 5

background image

5

Fabric Setting Chart

Ironing Instructions

Dry iron using spray if necessary.

Dry iron on the wrong side of the fabric.

Iron while fabric is still damp.

Use a press cloth and steam iron on the
wrong side of fabric.

Iron using spray if necessary.

For cotton, iron while still damp or use
spray. For linen, iron fabric on wrong side.

Temperature Setting

Off

Nylon,
Acrylic

Silk

Polyester

Wool

Rayon

Cotton,
Linen

Dr

y Iron

Steam Range

Steam

Setting

Caring for Your Iron

Self-Clean
To keep the steam vents clear of any
build-up, follow these instructions each
time you iron using steam.

1. Turn Temperature Control Dial to OFF

( O ) and set Adjustable Steam
Switch to Dry Iron . Fill iron with
water to 1⁄2 of its maximum capacity.

2. Turn Temperature Control Dial to

Linen setting and let iron heat for 2
minutes. Keep Adjustable Steam
Switch on Dry Iron .

3. Turn Temperature Control Dial to

OFF ( O ). Unplug iron and hold over
a sink with soleplate facing down.

4. Turn Adjustable Steam Switch to

MAX, while pressing Blast of Steam
button often. Boiling water and
steam will flow out of steam vents.
Allow all water to drain from iron.

5. Gently move iron front to back to allow

water to clean entire soleplate area.

6. If water still remains inside of sole-

plate, reheat iron as indicated in
Step 2. Boiling water and steam
could still flow out of steam vents.

Iron

1. The water tank of your iron should

be emptied after each use. Turn
Temperature Control Dial to OFF
( O ). Unplug the iron and hold over a
sink. Slowly tilt pointed end of iron
down over sink. Water will run out
of water tank opening.

2. After iron has completely cooled,

wrap cord loosely around the iron
and store in an upright position. Do
not store iron laying flat on soleplate.

Soleplate
1.
Never iron over zippers, pins, metal

rivets, or snaps, as these may
scratch the soleplate.

2. To clean occasional build-up on the

soleplate, wipe with a sudsy cloth.
Do not use abrasive cleansers or
metal scouring pads.

3. Always store iron upright in the heel

rest position.

••

••

•••

•••

840131800 ENv01.qxd 10/22/04 10:31 AM Page 5

This manual is related to the following products: