Philips ACT 7585 - Manual (Page 10)

POWER SUPPLY / GENERAL INFORMATION
10
Use only the AY 3170 adapter (4.5 V/300 mA direct
current, positive pole to the centre pin). Any other
product may damage the player.
1 Make sure that the adapter’s voltage
corresponds to the local voltage.
2 Connect the adapter to the 4.5V DC socket of
the player and to the wall socket.
Note: Always disconnect the adapter when you are not using it.
• Connect the supplied headphones to the p/LINE OUT
socket of the player.
Note: p/LINE OUT can also be used for connecting the
player to your HiFi system (with a signal lead) or to
your car radio (with a cassette adapter or signal
lead). In both cases, the volume of the player must
be set to position 8.
ESP
/ LINE OUT
VOL
F RESUME HOLD
Headphones AY 3678
Mains adapter (supplied or optionally available) English
Use your head when using headphones
Hearing safety: Do not play your headphones at a high volume. Hearing experts
advise that continuous use at high volume can permanently damage your hearing.
Traffic safety: Do not use headphones while driving a vehicle. It may create a hazard
and it is illegal in many countries. Even if your headphones are an open-air type
designed to let you hear outside sounds, do not turn up the volume so high that you
cannot hear what is going on around you.
ACT7585/01 eng 14/2/01 11:04 Page 10