Chapter 2- general installation, 1 installation location, 2 pre-installation checklist – Peripheral Electronics iPod2car User Manual
Page 13: 3 wiring connections, 11 common connection locations
2.1 Installation Location
Most installations will require you to remove the factory radio in order to plug in the vehicle
specifi c harness. Some vehicles may require you to connect the interface to a factory pre-
run CD changer cable. The location of these CD changer cables will vary by vehicle. Some
common locations of these cables are in the trunk, behind the glove box, and in or under a
center console. ( see Fig.2 below)
2.2 Pre-Installation Checklist
At this time and before beginning the installation:
• Your iPod’s Firmware should have been updated. (section 1.2)
• You should have your radio’s security code.(when applicable, see section 1.2)
• The dip-switches on the interface should have been set with the proper confi guration.
(see section 1.3)
• You should have in your possession the correct harness for your vehicle. (see sec. 1.3)
• You have determined your installation location. (see section 2.1)
If any of these steps has not been taken, STOP. Only when ALL of these steps have been
taken should you proceed with the rest of the installation.
11
Common Connection Locations
MENU
SE
EK
SC
AN
RD
S
VO
L
PW
R
TU
N
E
DS
P
BA
N
D
TA
PE
DIS
C
IN
FO
TR
AF
SE
EK
TY
PE
AU
TO
EQ
AU
TO
VO
I
3
4
1
2
5
6
iPod
iPod2car
interface
Vehicle Specifi c Harness
Chapter 2- General Installation
2.3 Wiring Connections
Some vehicle specifi c harnesses require wiring connections that involve splicing of wires. If
you are not confi dent in making these connections to your radio’s wiring harness, we recom-
mend you seek professional installation. You can visit www.iPod2car.com and click on the
dealer link at the top of the page to fi nd an authorized professional installer.