Pioneer PDK-TS01-L - Manual (Page 12)

12
Regarding the stand pipe screw holes when the stand is used as a desktop stand
Installation bolt 1
Plasma display
Stop screwing down the
bolt when the threads are
no longer visible.
Holes "a"
(holes in center of
plasma display)
Plasma display housing
C
B
A
C
´
B
´
A
´
B
A
C
´
B
´
A
´
C
2. Stand attaching to the Plasma Display
7 Normal Installation
Step 1. With the plasma display lying flat, insert and secure the two Installation bolts
1 (M8 x 20)
in the holes "a" located in the plasma display housing.
At this point, tighten these bolts
1 only until the threads are no longer visible when
viewed from t he side (you will be unable to attach the display if the bolts are screwed in
completely).
Installation bolt 1 (M8 x 20)
Table: Stand pipe screw holes when the stand is used as a desktop stand
Plasma display model
50"
43"
Specifications
Normal use
With optional speakers attached to both sides of display
Without optional speakers
With optional speakers attached to both sides of display
With optional speakers attached at bottom of display
Screw holes used with
stand orientation
B B'
A A'
B B'
Note: Holes C and C' are for attaching options available separately, etc.