beautypg.com

Troubleshooting, Care and maintenance – PYLE Audio PYD-1918 User Manual

Page 15

background image

4. To playback the recorded sample ONCE, turn the SAMPLER MODE switch to SINGLE, and press

START/STOP. The LED will go on, indicating that a sample is playing. Pressing START/STOP

during playback will stop the playback.

Each time you press the START/STOP control, the unit will replay the recorded sample from the

beginning and play it through the end of the recorded sound. Rapid, consecutive pressing of the

START/STOP button will create an interesting stuttering effect.

5. To playback the record sample repeatedly (”looping”), set the SAMPLER MODE switch to

REPEAT, and press START/STOP. The mixer will play the sampled recording all the way through,

and thenrepeat it until you press the START/STOP button.

6. To adjust the speed of the playback signal, rotate the SAMPLE PITCH control to reduce or

increase the pitch of the sample during playback.

7. To adjust the level of the sample playback as it enters the mix, rotate the SAMPLE LEVEL

to increase or decrease the level.

Troubleshooting

Your mixer should require very little maintenance. If you have problems, refer to the chart below

for possible solutions. If you cannot solve the problem, contact a qualified technician for assistance.

Care and

Maintenance

Your Pyle Pro Mixer is an example

of superior design and

craftsmanship. The following

suggestions will help you care for

your mixer so you can enjoy years

of use:

• Keep the mixer dry. If it gets wet,

wipe immediately.

• Use the mixer only in well-

ventilated installations.

• Handle the mixer gently and

carefully - do not drop!

• Keep the mixer away from dust

and dirt.

• Wipe occasionally with a damp

cloth to keep it looking new. Do not

use harsh chemicals, solvents or

detergents!

PROBLEM

POSSIBLE SOLUTION

Hum from PHONO

• Check that the turntable’s ground wire (usually black or green) is fastened securely to the GROUND

SCREW on the mixer input panel

No signal from an

audio input

source

• Check the control setting

• Check the connection between the mixer and the input source

Nothing works

• Check the AC connection. Make sure the AC outlet is “live.”

• Check the power connection to the rest of the system (receiver/amplifier, etc.)

Hum from other

source

• Make sure there are no low level inputs connected to the LINE input jacks

Feedback is

present

• Move the microphone further away from the output speakers, or use a directional microphone

Pyle Pro Mixer Owner’s Manual –13

Please complete warranty card, detach and return

PYLE PRO Audio, Inc.
1600 63rd Street
Brooklyn, NY 11204

Place

Stamp

Here