Pioneer VSX-21 - Manual (Page 43)

43
SET UP
OPERA
TION
Other Operations
Recording from Video Components
The following operations show you how to record audio and video to the video tape recorder connected to the VCR 1 or
VCR 2 jacks.
1
Select the component you want to record.
Be sure to press SIG. SELECT on the remote or SIGNAL SELECT on the
front panel to choose “ANALOG”. (Refer to “Switching ANALOG/
DIGITAL signal input” on page 29.)
2
Prepare the program source.
(Load the DVD or LD, etc.)
3
Insert a blank tape into the video tape recorder (VCR 1).
4
Start recording on the video tape recorder, then start
playback from the source component.
1
1
DVD/LD
VCR 1
TV/SAT CD
TUNER
VCR 2 MD/TAPE
TV CONTROL
RECEIVER
DSP MODE
CH.SELECT ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2 3
5
0
6
9 +10
TV/VCR CLASS
7 8
4 1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
RECEIVER TV
MUTING
CN.LEVEL EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
SIG. SELECT
SIGNAL SELECT
memo The receiver’s volume, balance, tone (BASS, TREBLE, and LOUDNESS), and surround effects have no effect
on the recorded signal.
memo • Recording cannot be made from analog to digital, and similarly
from digital to analog.
• When recording a DVD, the recorded image may flicker or be
difficult to view because of the copy protection signal
programmed on the DVD.