Precor EFX534 - Manual (Page 18)

page 18
C O M M E R C I A L P R O D U C T S D I V I S I O N
19. Attach the left and right handlebars. Diagram 13. Perform the following
steps on one side of the unit and then, repeat the steps on the opposite side.
a. Remove the three bolts (E) and washers (F) from the Hardware kit. Place
the washers on the bolts.
b. Attach one handlebar at a time. Note that the handlebars’ mounting holes
are smooth on one side and slightly protrude on the other side. Place the
protrusions against the handlebar brackets.
c. Align the holes and insert the three bolts (E) and washers (F). Thread the
bolts (E) into the holes using your fingers.
d. Tighten the bolts securely using a 1/2-inch socket wrench.
e. Repeat steps a. through d. to secure the opposite handlebar.
Diagram 13 Secure the
handlebars.
Protrusions
Handlebar
bracket
Tighten bolts securely.
Diagram 14 Secure the
handlebars to the
pivot arm.
Shoulder bolt (C)
Handlebar
5/16-inch hex key
Pivot arm