ProSpot Fitness P-600 - Manual (Page 2)

Instructions for Assembly of the ProSpotfitness® P-600
• Before assembly, choose a safe location for your PROSPOTfitness® P-600. The PROSPOTfitness® P-600
has a footprint of approximately 6’x 6’. The barbell is approximately 7’ long. Locate your PROSPOTfitness®
P-600 away from any source of water. Do not allow any liquid to be near the machine or spilled on any
electrical part. Do not insert any object into the electrical box.
• Approximate assembly time is 1-1/2 hours.
• A flat area of 9’ x 9’ will be required to assemble and properly use the PROSPOTfitness® P-600.
• You will need the following tools and a helper to complete the assembly:
• Enclosed you will find the following tools:
• 3 mm Allen Wrench
• 4 mm Allen Wrench
• 6 mm Allen Wrench
• 3/16" Allen Wrench
• 9/16" Allen Wrench
• You will need the following tools:
• 16 mm Hex Head Wrench
• 18 mm Hex Head Wrench
• Philips Screw Driver
•
Floor Padding, such as cardboard, to avoid scratching your floor during assembly.
• A good pair of scissors will be helpful in separating the parts from one another while removing them from
the cartons.
• HAND TIGHTEN all bolts. DO NOT fully tighten bolts until instructed to do so.
• Assistance by a second person is recommended for some steps of this assembly.
• Before assembly, separate and identify the right-sided parts from the left-sided parts. These parts are easily
distinguished by the manner in which the pre-drilled holes align with corresponding parts, or are identified by
“L“ & “R” stickers.
• The PROSPOTfitness® P-600 uses several different lengths of bolts. Be careful to use the correct length of
bolt called for at each step of assembly. Refer to the sizing charts provided.
• WARNING: Never perform any maintenance on the ProSpotfitness®
P-600 while the Power Supply is plugged into the wall !!!
ALWAYS REMEMBER:
After the initial set up of the system or after performing any
service on the unit, RESET the Computer on your ProSpot system before using it. Just unplug
the power supply from the Electronic Box, wait 30 seconds and plug back in. Resetting the
Computer allows it to recalibrate and work to its greatest efficiency.
--2--