Philips AZD208/05 - Manual (Page 4)

Connect the blue wire to the terminal marked N or coloured black. •
Connect the brown wire to the terminal marked L or coloured red. •
Do not connect either wire to the earth terminal in the plug, •
marked E (or e) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead - not simply over the two wires.
a Remove fuse cover and fuse.
b Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI
approved type.
c Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place.
Warning
Never remove the casing of this apparatus. •
Never lubricate any part of this apparatus. •
Never place this apparatus on other electrical equipment. •
Keep this apparatus away from direct sunlight, naked flames or heat. •
Never look into the laser beam inside this apparatus. •
Ensure that you always have easy access to the power cord, plug or •
adaptor to disconnect this apparatus from the power.
Where the MAINS plug or an appliance coupler is used as the disconnect •
device, the disconnect device shall remain readily operable.
Caution
Use of controls or adjustments or performance of procedures other •
than herein may result in hazardous radiation exposure or other
unsafe operation.