Precor s 932i - Manual (Page 35)

Treadmill: Adjusting the Running Belt
If you are unsure about adjusting the running belt, call Precor
Customer Support (refer to Obtaining Service).
CAUTION: For your safety, use the power switch to turn Off the
treadmill before making any adjustments. Do not adjust the
running belt when someone is standing on the equipment.
1. Locate the right belt adjustment bolt in the rear end cap of the
treadmill as shown in the following figure.
Figure 4: Location of the adjustment bolt
To determine left and right, stand at the rear of the treadmill and
face the display. Make all belt adjustments on the right rear
corner bolt using the hex key provided.
y
2.
If the belt is off center to the LEFT, turn the adjusting bolt ¼
turn counterclockwise, which moves the running belt to the
right.
y
Important: Do not turn the adjusting bolt more than ¼ turn at a
time. Overtightening the bolt can damage the treadmill.
If the belt tracks off center to the RIGHT, turn the bolt ¼ turn
clockwise; this moves the belt to the left.
Recheck the alignment of the running belt by repeating the
steps found in Treadmill: Checking the Alignment of the
Running Belt.
Product Owner's Manual: Maintenance 33