Philips SBC SP 370 - Manual (Page 6)

Note: Although the unit code on the Power switch can be set from 1
to 16, the remote control can only operate Power switches with
unit code set from 1 to 8.
• To operate Power switches with unit code 1-4, the toggle switch on
the remote control should be set to the left (1-4).
– The first 4 buttons on the remote control correspond with unit code
1 to 4 respectively.
– If the toggle switch on the remote control is set to the right (5-8),
the first 4 buttons correspond with unit code 5 to 8 respectively.
INSTALLATION
Your appliance must be connected to the Power switch before you can
control it with the remote control
(fig. 2).
• Select the appliance (e.g. a lamp) you want to control and plug it
into the Power switch (fig. 2).
• Please check the power consumption of the selected appliance. The
Power switch can control appliances with a maximum power rating
of 1000 Watts!
• If the selected appliance has its own ON/OFF switch, make sure it
is switched on.
English
6