Printek Mobile Thermal MtP400 - Manual (Page 31)

Printer Configuration
Emulation Emulation
Printek
Possible Values: Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump
This feature sets the family of printer commands that may be used by a host application program to control the
various capabilities of the printer. The printer will only respond to commands valid for the currently selected
emulation. For more information, please refer to the MtP400 Series Programmer’s Manual.
Bluetooth Interface
INTERFACE MENU
Bluetooth
Note that “Bluetooth” must be displayed on the bottom line of the display in order to access the following
features and for this interface to be active when Setup is exited.
Emulation Emulation
Printek
Possible Values: Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump
This feature sets the family of printer commands that may be used by a host application program to control the
various capabilities of the printer. The printer will only respond to commands valid for the currently selected
emulation. For more information, please refer to the MtP400 Series Programmer’s Manual.
Note: After pressing the Enter Button to move from Emulation to Pairing Mode, the printer will pause
and display “Waiting for Bluetooth” while reading the current configuration from the Bluetooth
interface module.
Pairing Mode Pairing Mode
Paired
Possible Values: Paired*, Unpaired
This feature allows Bluetooth pairing to occur between the printer and the connecting device whenever Security
is required by either device. Pairing requires that the PIN on the printer and the connecting exactly match each
other.
25