Philips DC200 - Manual (Page 2)

ENGLISH
Step A
Connect the supplied mains adapter to the
set's 9V DC jack and the plug into a wall outlet.
Step B
How to set the Clock & Alarm time
Press and hold SET TIME or 1 ALM/2 ALM
until the hour digits fl ash.
Press and hold ∞ § to adjust time.
Press SET TIME or 1 ALM/2 ALM to confi rm.
Repeat the steps 2-3 to complete all the
other time items setting.
Selecting the Alarm mode
4. Press ∞ § /SOURCE repeatedly to select
your desired alarm mode.
For Nature sound mode, press ALBUM/PRESET
-/+
1 / 2 to select your desired nature sound track.
Helpful hints:
If you have selected TUNER alarm mode, make
sure you have properly tuned to a station before
turning off the set (
See Tuning to radio station).
If you have selected iPod/USB alarm mode,
make sure you have connected the compatible
iPod player or USB device, or the buzzer mode
will be selected automatically.
3 ways to switch off the alarm
Either press briefl y: POWER 2 or REPEAT
ALARM/ BRIGHTNESS CONTROL .
Press 1 ALM or 2 ALM.
Step C
Tuning to radio station
Press SOURCE once or more to switch on
the radio.
Press ∞ § repeatedly to tune to your
station.
•
1.
2.
3.
•
•
–
–
•
•
1.
2.
To store a preset, press PROG to activate the
programming, and then press ALBUM/PRESET
-/+
1 / 2 to select a desired preset number, and
then press PROG again to confi rm.
To store preset radio stations automatically, press
and hold PROG for more than two seconds.
Step D
Playing Apple iPod using DC200
Remove the top cover of dock.
Snap the correct adaptor (supplied) into the
dock to provide a snug fi t for the iPod player.
The indication on the adaptor’s back fi ts
specifi c iPod player.
3. Snap the compatible iPod into the dock
connector.
4. Press SOURCE repeatedly to select the iPod
mode.
The connected player will play automatically.
Helpful hints:
By using the buttons ( 2;, ∞ , § and
VOLUME ) on the DC200, the following iPod
playback features are available: Play/Pause,
selecting next/previous track, fast forwarding/
rewinding and changing volume.
Refer to the user manual supplied for detailed
descriptions of “Compatible portable player”,
“Selecting the correct dock adaptor” and the
important notes for dock operation.
Step E
Playing a USB mass storage device
Make sure that your DC200 is being powered
by AC mains.
Press SOURCE repeatedly to select the USB
mode.
Plug a compatible USB mass storage device to
DC200’s USB port marked
.
Playback will start automatically.
•
•
1.
2.
•
•
–
–
1.
2.
3.
➜
DC 9V
A
B1, B3
3
C2
C1, D4, E2
3
D1, D2, D3
E3
B2, B4, C2
DC200_05_QSG.indd 2 DC200_05_QSG.indd 2 2008-02-15 1:32:53 PM 2008-02-15 1:32:53 PM