Philips FLEXCARE00 HX6911 - Manual (Page 8)

Brushing routines
Go Care routine
1-minute brushing cycle in the Clean mode, for a quick clean. You hear the
Quadpacer signal at 15-second intervals.
Max Care routine
3-minute brushing cycle that combines the Clean and Massage modes in
one routine for a thorough mouth clean. There are 30 seconds of Clean
mode and 15 seconds of Massage mode for each of the 4 sections of your
mouth. You hear the Quadpacer signal at 45 second intervals.
Note: When the Sonicare is used in clinical studies, the default
2-minute Clean mode must be selected. The handle has to
be fully charged. Deactivate the Easy-start feature. For areas
where excess staining occurs, an additional 30 seconds of
brushing time can be spent to help remove stains.
Features
Easy-start
This Sonicare model comes with the Easy-start feature activated.
The Easy-start feature gently increases power over the fi rst 14
brushings to ease into the Sonicare experience.
Note: Each of the fi rst 14 brushings must last at least 1 minute to properly
move through the Easy-start ramp-up cycle.
Deactivating or activating the Easy-start feature
1 Attach your brush head to the handle.
2 Place the handle on the plugged-in charger or sanitiser.
To deactivate Easy-start:
Press and hold the on/off button for 5 seconds. You hear 1 beep to indicate
that the Easy-start feature has been deactivated.
To activate Easy-start:
Press and hold the on/off button for 5 seconds. You hear 2 beeps to
indicate that the Easy-start feature has been activated.
Note: Using the Easy-start feature beyond the initial ramp-up period is not
recommended and reduces the Sonicare’s effectiveness in removing plaque.
Smartimer
The Smartimer indicates that your brushing cycle is complete by
automatically switching off the toothbrush at the end of the brushing cycle.
Dental professionals recommend brushing no less than 2 minutes twice a
day.
-
-
-
-
ENGLISH 8