Philips LX3000 - Manual (Page 29)

Digital Output, Night Mode 29
• You can activate Night Mode
quickly by pressing NIGHT on the
remote control.
Helpful Hint
Digital Output
Set Digital Output according to your audio connection.
1 While playback is stopped, press SYSTEM MENU. Press ;
or - to select the icon.
2 Press 9 repeatedly to select z z , then press : :.
3 DIGITAL OUTPUT will be selected. Press :
:.
4 Press 9 or 8 to select ALL, PCM 96K, or PCM 48K, then
press OK.
● Choose ALL if you used the DIGITAL OUT - COAXIAL or
OPTICAL jack on the DVD Receiver to connect to optional
audio equipment.
● Choose PCM 96K if you connected the DVD Receiver to optional
audio equipment that is capable of processing sampling rates of 96
kHz.
● Choose PCM 48K if you connected the DVD Receiver to optional
audio equipment that cannot process sampling rates over 48K.
Check the owner’s manual of the optional audio equipment.
5 Press SYSTEM MENU to remove the menu.
DIGITAL OUTPUT ALL
NIGHT MODE PCM 96K
CENTER DELAY PCM 48K
REAR DELAY OFF
TEST TONE
SPDIF/RAW OUTPUT
Night Mode
Set Night Mode to On to level the volume during Disc playback. This
reduces the highs and lows of the volume.
1 While playback is stopped, press SYSTEM MENU. Press ;
or - to select the icon.
2 Press 9 repeatedly to select z z , then press :
:.
3 Press 9 to select NIGHT MODE, then press :
:.
4 Press 9 or 8 to select ON or OFF, then press OK. OFF is
the default setting.
5 Press SYSTEM MENU to remove the menu.
DIGITAL OUTPUT
NIGHT MODE OFF
CENTER DELAY ON
REAR DELAY
TEST TONE
NIGHT MODE SET TO OFF
1,5
1-4
1,5
1-4