2 how to charge the battery, 3 adjusting the trimming height, 4 leveling the beard height – Panasonic ER214/216 User Manual
Page 8: 5 shaping the beard and aligning the edges

8
2 How to charge the
battery
Using the rechargeable battery
Charge the battery by plugging the
Trimmer into an AC source using the
cord. The switch should be set to “0-
charge” during charging. Charge the
trimmer fully for 24 hours before us-
ing it for the first time, or when it has
not been used for more than 6
months. For normal use, charge it
fully for 1 hour. A full charge will give
40 minutes of use.
• The lamp lights while the battery is
being charged and flashes when
the charging is completed.
• The trimmer will become warm
while the battery is being charged,
but this is not a malfunction.
Using an AC power source
Plug the Trimmer into an AC power
source using the cord with the switch
set to “0-charge”. Wait about 1
minute, then switch the Trimmer on.
After use, return the switch to the “0-
charge” position.
3 Adjusting the trimming
height
1
Attach the trimming height attach-
ment (a) to the body.
2
The trimming height can be ad-
justed in 12 steps (b).
3
Press the trimming height adjust-
ment switch (c) and adjust to the
desired trimming height.
Indicator
Beard Length
1
2.0 mm
•
3.0 mm
3
4.5 mm
•
6.0 mm
5
7.5 mm
•
9.0 mm
7
10.5 mm
•
12.0 mm
9
13.5 mm
•
15.0 mm
11
16.5 mm
•
18.0 mm
4 Leveling the beard
height
1
Adjust the trimming height.
2
Trim with upward movements.
(Hold the comb part of the trim-
ming height attachment against
your skin in the opposite direction
to the hair growth.)
When trimming a lot of beard, the
beard cuttings accumulate inside the
trimming height attachment. If this
happens, empty the attachment
when necessary.
5 Shaping the beard and
aligning the edges
Remove the trimming height attach-
ment from the body.
Trim with the blade at a 90
° angle to
the beard.
(Trim a little at a time in order to pre-
vent trimming too much.)
OS01L015_ER214-ER216_E
1/17/02, 4:43 PM
8