Porter-Cable 7537 - Manual (Page 8)

8
Fig. 4
C
Fig. 5
F
B
D
C
A
E
ADJUSTING DEPTH OF CUT
1. D I S C O N N E C T
TOOL FROM POWER SOURCE.
2. Loosen clamp screw (A) Fig. 5.
3. While holding base (E), turn
motor unit (F) Fig. 5
COUNTERCLOCKWISE until the tip
of the bit is above bottom surface of
base.
4. Set router on flat wood surface.
5. Turn motor unit (F) Fig. 5
CLOCKWISE until bit touches the
wood surface.
6. Tighten clamp screw (A) Fig. 5.
7. Rotate depth adjusting ring (B)
Fig. 5 until the zero-line (C) is
opposite the index line (D) on the
housing.
8. Loosen clamp screw (A) Fig. 5.
9. Tip the router so bit is clear of
the wood surface. Turn motor unit
(F) Fig. 5, CLOCKWISE until the
index line (D) on the motor housing
reaches the desired depth indicated
on the ring.
10. Tighten clamp screw (A) Fig. 5
firmly.
NOTE: Setting the index line to 1 /
4
" on the ring means the cutting
edge of the bit is exposed 1 /
4
" below the base.
OPERATION
Fig. 6
A
CONNECTING TO POWER
SOURCE
Before connecting
tool to power source, CHECK TO
SEE THAT THE SWITCH IS IN
THE “OFF” POSITION. Also,
check the power circuit to see that
it is the same as that shown on
specification plate of the tool.