Tv volume/mute punch-through feature, Vcr/dvd punch-through feature, Code setup – Philips PM3 User Manual

Page 3: Battery installation, Battery saver, Code saver, Power-on default, Setup setup, cont, The remote powers on in tv mode

SUB

TITLE

CODE

SLEEP

PREV.

CHAN

REPEAT

INFO

SELECT

IN/OUT

VOL

CBL

QUIT

POWER

TER/CH

TER/CHA

VCR

DVD

TV Volume/Mute Punch-Through Feature

The TV Volume/Mute punch-through feature lets you
control the Volume and Mute function of your TV in any
mode programmed to be a VCR, DVD, CABLE or SAT
device, without needing to change to TV mode.

VCR/DVD Punch-Through Feature

Punch-through to VCR/DVD mode i.e. the 6 keys (PLAY,
PAUSE, STOP, FF, REWIND, and REC) is only allowed
in modes programmed for TV or Cable codes.

Code Setup

The

CODE SEARCH

button is used to setup the remote.

You can either setup the remote using the code for your
brand of product, from the code tables (on separate
sheet), or you can search through the library of codes
until you find a code that works for your product.

Please refer to “Programming with Code Search” on page
11 for more information on using the code search feature
to learn how to search through the library of codes for
your products.

NOTE: You can store any kind of code under any mode
(except TV). I.E. you can store a VCR code under the
CBL button, or a DVD code under the VCR button, etc.
However, you can only store TV codes under the TV
button.

CODE SEARCH

Battery Installation

1. On the back of the remote,

push down on the tab and
lift the cover off.

2. Match the batteries to the

+ and - marks inside the
battery case, then insert 2
AAA Alkaline batteries.

3. Press the battery cover

back into place.

Battery Saver

Your remote automatically
turns off if the buttons are
depressed more than 30
seconds. This will save your
batteries should your remote
get stuck in a place where the
buttons remain depressed
(e.g., between the sofa
cushions).

Code Saver

You will have up to 10 minutes to change the batteries
in your remote without losing codes you have
programmed. However, do not press any buttons until
batteries are installed in the remote. If buttons are
pressed without batteries in the remote, all codes will be
lost.

Power-On Default

The remote powers on in TV mode.

Setup

Setup, cont.