Philips PH0900L - Manual (Page 7)

2. Insert one end of the provided six-foot phone cord into a
functioning wall phone jack. Plug the other end of same
phone cord into the phone connector on the base unit
labeled LINE.
3. After you have plugged the base unit into an electrical out-
let, plug the extension unit into an A/C outlet where you
desire connection.
NOTE: The indicator light on the extension unit will blink
red.As soon as it recognizes the base unit, the
indicator light will then illuminate green. The
indicator light on the base unit will illuminate
green as well, just after it has recognized the
extension unit.
4.Your wireless phone jack is now ready for use.
Test
1. To ensure you have completed the installation successfully,
use a handset phone cordless phone or a phone-line testing
device to help verify your extension unit has a dial tone.
NOTE: The indicator light on base and extension units
will blink green when the handset connected to
the extension unit is taken off hook.
2. Plug your chosen handset telephone, cordless telephone or
phone-line testing device into the single phone connector
on your extension unit, and check for a dial tone. Is there a
dial tone? If so, you have successfully set up the link between
the base and extension units.
EN
System Setup
7