Peavey Express 112 S - Manual (Page 5)

SPECIFICATIONS
Rated Power & Load:
Power specs measured with
Dynamics
W into 8 ohms
4 ohms not recommended
Power Clipping: (Typically)
1 V AC line)
W into 8 ohms
Frequency Response:
3 Hz to
W into 8 ohms
Hum & Noise:
Greater than below rated
power
Power Consumption:
W Hz, V AC
(Domestic)
SECTION
The following specs are measured
1 with the controls preset
as follows:
Effects Send:
Load Impedance: 1 K ohm
or greater
Push Bright, Off (Out) Nominal Output Level:
Channel Select Normal (Out) V
Low&High
Mid 0
& Post Gain
Gain & Thrash, Off (Out)
Normal Levels are with normal
volume 5
Minimum Levels are with normal
volume
High Gain Input:
Impedance: High 1 M ohm
Nominal Input Level:
Minimum Input Level:
Maximum Input Level: 0
Low Gain Input:
Impedance: High K ohms
Nominal Input Level:
Minimum Input Level:
Maximum Input Level: 6
Effects Return:
Impedance: High K ohms
Designed Input Level: -
V
(Switching jack provides Effects
Send to Effects Return connection
when not used)
System Hum & Noise
Nominal Input Level:
Hz to
below rated power
Equalization:
Special low, mid, high passive
type
Push Bright: 2
Push Thrash: notch 1
in Lead channel
Push Gain: Increases Lead gain
External Footswitch Functions:
Lead Channel Defeat (when selected
with button)
Reverb Defeat
HIGH GAIN
REVERB LEVEL
INPUT
SWITCH
LOGIC
FOOT
SWITCH
FOOTSWITCH
PUSH
BRIGHT
CLEAN
BLOCK DIAGRAM
5