Operation – PYLE Audio PLTVRDIN65 User Manual

Page 16

OPERATION

Remote Sensor
There is a remote sensor on the front
panel. On the monitor, there is another
remote sensor to receive remote control
signal. You can point the remote control
handset to the remote sensor on the front
panel (when the monitor doesn’t stretch
out) or the remote sensor on the monitor
panel (when the monitor stretches out)
and press function keys on the remote
control to control the DVD unit.
The unit is also connected to an external
remote receiver (See the electrical
connection diagram), and the function is
the same with the remote sensor on the
front panel or on the monitor panel.

Notes:

∆

The external remote receiver is placed

near the monitor for the best reception
of the remote signal.

∆

If the angle of the monitor from vertical

exceeds

(Especially the distance

exceeds 3m.), controlling the DVD unit
through the remote sensor on the front
panel may not be effictive. You are
suggested to use the external remote
receiver.

6.5 Inch TFT Display
When the monitor stretches out, the 6.5
inch color TFT display can show the
current state of the unit.

Volume Level Adjustment
Press VOL+/- buttons on the remote
control to increase or decrease the
volume level.

Mode Selection
Press MODE button on the remote
control to select among DVD, RADIO,TV,
AV and RGB mode.

Reset
Reset button is placed on the front panel
and must be activated with either a
ballpoint pen or thin metal object. The
reset button is to be activated for the
following reasons:
- Initial installation of the unit when all

wiring is completed.

- All the function buttons do not operate.
- Error symbol on the display.

Picture mode Adjustment
Press PICT button on the monitor panel,
the picture mode will show on the
display, repeatedly press PICT button to
select among BRIGHT, CONTRAST,
COLOR, TINT (For the unit with NTSC
system) and SCREEN.
(For the unit with PAL system):

(For the unit with NTSC system):

Press +/- buttons on the monitor panel
to adjust the selected item. The
corresponding value will show on the
display.

NOTE (FOR THE UNIT WITH TEL-
MUTE AND BRAKE FUNCTION)

• When there is an incoming call, the unit

will be in mute state, and “TEL MUTE”
appears on the screen display.

• If the brake wire isn’t connected to the

ground (when driving, in BRAKE OFF),
the picture will not be shown on the
screen in DVD/TV/AV mode for safety
purpose. Only the audio will be heard.

PICTURE

BRIGHT

CONTRAST

COLOR

SCREEN

16:9