ProForm 750 PFTL73105.2 User Manual

Page 8

Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place; the large allen
wrench is used to adjust the walking belt (see page 23).

5. Place the treadmill in the storage position (see HOW TO

FOLD AND MOVE THE TREADMILL on page 20).

Next, place the cylinder end of the Shock (92) near the
bracket on the base of the Uprights (84).

See the two small inset drawings. Using your fingernail
or the end of a screwdriver, press on the end of the
Shock Pin (25) to loosen it from the Shock (92). Next, ro-
tate the Shock Pin and pull it out of the Shock.

Be care-

ful to avoid losing the Shock Pin.

See drawing 5a. Press the cylinder end of the Shock (92)
onto the ball on the bracket. Next, insert the end of the
Shock Pin (25) through two of the small holes in the end
of the Shock. Then, rotate the Shock Pin until it clips
onto the Shock.

Bracket

Cylinder

Bracket

6. Raise the Shock (92) to a vertical position. Remove the

Shock Pin (25) from the raised end of the Shock as de-
scribed in step 5. If necessary, rotate the Shock to align
the end of the Shock with the ball on the bracket on the
Frame (58).

Next, press the Incline increase and decrease buttons
until the ball on the bracket is aligned with end of the
Shock (92). Then, press the end of the Shock onto the
ball. Note: It may be necessary to press the end of the
Shock onto the ball while the Frame is moving.

See drawing 6a. Insert the Shock Pin (25) into the two in-
dicated small holes in the end of the Shock (92). Then,
rotate the Shock Pin until it clips onto the Shock. Note:
Extra Shock Pins are included.

Press the Incline decrease button until the treadmill is at
the lowest incline level. Then, unplug the power cord.

Holes

Bracket