Philips MAGNAVOX PR1390C1 - Manual (Page 20)

TIMER ACTIVE ON
CHANNEL 12
START TIME - - : - - AM
TIMER ACTIVE ON
CHANNEL 12
START TIME 08:30 AM
12
POWER
SLEEP CLOCK CC
1 2 3
6 5 4
7 8 9
0 A/CH SURF
STATUS
EXIT MENU
MUTE
SMART SMART
SOUND PICTURE
CH VOL
2
3
4
1
8:30
CHANGING
TO CHANNEL 6
IN 30 SECONDS
U sed along with the Clock fea-
ture, you can select a specific
time the television will turn on
when the Timer Active control is
turned ON.
Press the CLOCK button to
display the Clock onscreen menu.
Press the CURSOR UP ▲ or
CURSOR DOWN ▼ button until
the words START TIME are high-
lighted.
Enter the time to turn on the
TV using the NUMBERED but-
tons. If the first number is a single
digit first enter a zero then the digit
(i.e., press “0”, then press “8”).
Press the CURSOR RIGHT ᮣ
or CURSOR LEFT ᮤ buttons to
set either AM or PM time.
S
ETTING THE
TV’
S
S
TART
U
P
T
IME
BEGIN
S MART H ELP
Remember: Be
sure to set the Timer
Active to ON.
The onscreen menu will
time out and disappear
from the screen when you
finish, or you can press the
STATUS/EXIT button to
clear the menu from the
screen.
If the TV is in use when the START TIME control is about
to be activated, the screen will display a warning stating it's
going to change channels in 30 seconds. It will appear like
the screen shown below and change to the selected start up
channel. Pressing any button on the remote within this
count down will cancel the change.
SET CLOCK 10:00 AM
TIMER ACTIVE ON
CHANNEL 12
START TIME - - : - - AM
POWER
SLEEP CLOCK CC
1 2 3
6 5 4
7 8 9
0 A/CH SURF
STATUS
EXIT MENU
CH VOL
3
1
2
U sed along with the Clock fea-
tures, you can select a specific
channel that the television will tune
to when the Timer Active control is
turned ON.
Press the CLOCK button to
display the Clock onscreen menu.
Press the CURSOR UP ▲ or
CURSOR DOWN ▼ button until
the word CHANNEL is highlighted.
Press the number buttons to
enter the start up channel you
would like the television to start on.
A
CTIVATING THE
S
TART
U
P
C
HANNEL
BEGIN
S MART H ELP
Remember: Be sure to set
the Timer Active control to
ON.
The onscreen menu will time out
and disappear from the screen when
you finish, or you can press the
STATUS/EXIT button to clear the
menu from the screen.
20