Pride Mobility QUANTUM 600 SP - Manual (Page 27)

Quantum 600 Series www.pridemobility.com 27
SCREW
CAM
V . C O M F O R T A D J U S T M E N T S
Figure 19. Foot Platform Adjustment
FOOT PLATFORM BRACKET
FOOT PLATFORM RETAINING PIN
QUICK RELEASE
FASTENERS
LEVER (OPEN)
BOLT
NUT
UNCLAMPED CLAMPED
LEVER (FULLY
CLOSED)
SECUREMENT NUT
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several
different heights.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot
platform bracket. See figure 19.
2. Loosen the foot platform securement nut one-half turn.
3. Raise or lower the foot platform to the desired
height.
4. Reinstall the quick release fasteners into the foot
platform bracket and tighten.
5. Tighten the foot platform securement nut.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot
platform bracket. See figure 19.
2. Move the foot platform in or out to the desired
depth.
3. Reinstall the quick release fasteners into the foot
platform bracket and tighten.
Quick Release Fasteners: The foot platform is
attached to the power base with two quick release fas-
teners. See figure 19. Each quick release fastener con-
sists of a bolt, a lever, and a nut. See figure 20. The
lever has a cam on the end that allows it to clamp into
place. The quick release fastener has two states:
clamped and unclamped. When the lever is open, the
quick release fastener is unclamped. When the lever is
closed, the quick release fastener is clamped.
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-
quarter or one-half turn.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a
socket or wrench. See figure 21.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew.
2. Turn the screw to raise or lower the front of the foot
platform.
Figure 21. Underside of Foot Platform
Figure 20. Quick Release Fastener Operation