Peavey Combo 7/9780300698 - Manual (Page 8)

8
POWER AMPLIFIER SECTION
RATED POWER & LOAD:
210W RMS into 4 ohms (with DDT
™ compression)
300W RMS into 2 ohms (with DDT ™ compression)
POWER AT CLIPPING (typically 5% THD, 1 kHz 120 VAC line):
130W RMS into 8 ohms
230W RMS into 4 ohms
340W RMS into 2 ohms
FREQUENCY RESPONSE:
+0, -1 dB, 100mW to 200W RMS, 20 Hz to 20 kHz into 4 ohms typically below 0.1%
THD
DDT ™ :
Dynamic Range: Greater than 20 dB
Maximum THD: Below 0.5% THD for 6 dB overload
Below 1% THD for 20 dB overload
HUM AND NOISE:
Greater than 105 dB below rated power
POWER CONSUMPTION:
800W, 50/60 Hz, 120 VAC
PREAMP SECTION
THE FOLLOWING SPECS ARE MEASURED AT 1 kHz WITH THE CONTROLS SET
AS FOLLOWS:
-10 dB pad: out
Pre Gain at 5
Post Gain at 10
Bright off (out)
Contour off (in)
Low set flat (0)
High set flat (0)
All EQ sliders centered (0)
Graphic select switch: out
Nominal levels are with Pre Gain set at 5
Minimum levels are with Pre Gain set at 10
PREAMP INPUT (Pad Out):
Impedance:
High Z, 220K ohms
Nominal input level: -17 dBV, .14 V RMS
Minimum input level: -37 dBV, .015 V RMS
Maximum input level: +7.6 dBV, 2.4 V RMS
PREAMP INPUT (Pad In):
Impedance:
High Z, 44K ohms
Nominal input level: -7.2 dBV, .435 V RMS
Minimum input level: -26 dBV, .048 V RMS
Maximum input level: +17.5 dBV, 7.5 V RMS
SPECIFICATIONS: