Philips JETSET CONTROL ION HP4882 - Manual (Page 7)

Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
◗
Check if the voltage indicated on the appliance corresponds to
the local mains voltage before you connect the appliance.
◗
Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the cord or the appliance itself is damaged.
◗
If the mains cord is damaged, it must be replaced by Philips, a
service centre authorised by Philips or similarly qualified persons
in order to avoid a hazard.
◗
Keep this appliance away from water! Do not use this product
near or over water contained in baths, washbasins, sinks etc.
When used in a bathroom, unplug the appliance after use since
the proximity of water presents a risk, even when the hairdryer is
switched off.
◗
For additional protection, we advise you to install a residual
current device (RCD) with a rated residual operating current
not exceeding 30mA in the electrical circuit supplying the
bathroom.Ask your installer for advice.
◗
Keep the appliance out of the reach of children.
◗
Never block the air grilles.
◗
If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grilles to make sure they
are not blocked by fluff, hair, etc.
◗
Always switch the appliance off before putting it down, even if it
is only for a moment.
◗
Always unplug the appliance after use.
◗
Do not wind the mains cord round the appliance.
◗
You may notice a characteristic odour when using this hairdryer.
This is caused by the ions that are generated and it is not harmful
to the human body.
◗
Do not probe the ion generator with metal objects.
ENGLISH 7