Cd player, Playing a cd, Selecting a different track – Philips AZ1006CD User Manual
Page 7: Finding a passage within a track, Programming track numbers
Playing a CD
This CD player plays Audio Discs including
CD-Recordables and CD-Rewritable.
•
MP3 CD-ROMs, CD-I, CDV,VCD, DVD or
computer CDs are not possible for playback
on this set.
IMPORTANT!
•
CDs encoded with copyright protection
technologies by some record companies may
be unplayable by this product.
1
Adjust the source selector to CD.
2
Insert a CD/ CD-R(W) with the printed side
facing up and press the CD door gently
close.
➜ Display shows -- and later, the total
number of tracks. (See 2, 3)
3
Press
2; on the set to start playback.
➜Display:
2 and the current track number.
(See 4)
4
To pause playback press
2;. Press 2; again
to resume playback.
5
To stop CD play, press
9.
6
To switch off the set, adjust the source
selector to TAPE/OFF position and check
the cassette keys are released.
Helpful hints : CD play will also stop when:
- you open the CD compartment;
- you select MW, FM, or TAPE/OFF sound
source;
- the CD has reached the end of playback.
Selecting a different track
• Press SEARCH
∞ or § once or repeatedly
until the desired track number appears in the
display.
• In the pause/stop position, press
2; to start
playback.
Finding a passage within a
track
1
During playback, press and hold down
∞ /
§.
➜ The CD is played at high speed and low
volume.
2
When you recognize the passage you want
release
∞ / §.
➜ Normal playback resumes.
Helpful hints : When searching within a final
track and you reach the end of the last track,
the CD goes to stop mode.
Programming track
numbers
You may store up to 20 tracks in the desired
sequence. If you like, store any track more
than once.
1
In the stop position, press PROG to activate
programming.
➜ Display: PROG and 00 flash.
2
Press
∞ or § to select your desired track
number.
➜ Display: PROG and your desired track
number flash. (see 5)
3
Press PROG to store the desired track
number.
➜ Display: PROG and 00 flash for you to
program the next track. (see 6)
4
Repeat steps 2 to 3 to select and store all
desired tracks in this way.
5
To play your program, press
2;.
➜ Display: PROG flashes during program
playback
Helpful hints : If you try to store more than
20 tracks, the display will show --.
CD Player
AZ1006-Eng 3/25/05 14:28 Page 7