Philips EXPANIUM 4000AZ - Manual (Page 19)

English
19
If a fault occurs, first check the points listed below before taking the set for repair. Do
not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the warranty.
Troubleshooting
Problem Solution
No sound/power – Volume not adjusted. Adjust the VOLUME.
– Power cord not securely connected.
Connect AC power cord properly.
– Batteries dead /incorrectly inserted.
Insert (fresh) batteries correctly.
Display does not function – Electrostatic discharge.
properly/ No reaction to Switch off and unplug the set.
operation of any of the Reconnect after a few seconds.
controls
INSERT CD or CHECK DISC – No CD inserted, insert a CD.
indication – CD badly scratched or dirty.
Replace/ clean CD (see Maintenance).
– Laser lens steamed up. Wait until lens has cleared.
– CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W).
CD playback does not work – CD badly scratched/ dirty.
Replace/ clean CD (see Maintenance).
– Laser lens steamed up.
Wait until lens has acclimatized.
The CD skips tracks – Disc damaged or dirty. Replace or clean disc.
– SHUFFLE or a program is active.
Quit SHUFFLE / program mode(s).
XP AZ 4000/17 18-09-2001 15:04 Pagina 19