Philips PM435 - Manual (Page 6)

11 10
PREV PREV PREV PREV
CHAN CHAN CHAN CHAN
MUTE MUTE MUTE MUTE
VVVVOOOOL
LLL ++++
POWER POWER POWER POWER
VCR VCR VCR VCR
TV TV TV TV
CODE CODE CODE CODE
SEARCH SEARCH SEARCH SEARCH
ENTER ENTER ENTER ENTER TV/VCR TV/VCR TV/VCR TV/VCR
SAT SAT SAT SAT
PIP PIP PIP PIP
DVD DVD DVD DVD
CHAN CHAN CHAN CHAN+ + + +
C C C CH HH HA AA AN N N N
TOGGLE TOGGLE TOGGLE TOGGLE
C C C CC C C C
REPEAT REPEAT REPEAT REPEAT
SUBTITLE SUBTITLE SUBTITLE SUBTITLE SLEEP SLEEP SLEEP SLEEP
INPUT INPUT INPUT INPUT
PREV PREV PREV PREV
CHAN CHAN CHAN CHAN
MUTE MUTE MUTE MUTE
VVVVOOOOL
LLL ++++
POWER POWER POWER POWER
VCR VCR VCR VCR
TV TV TV TV
CODE CODE CODE CODE
SEARCH SEARCH SEARCH SEARCH
ENTER ENTER ENTER ENTER TV/VCR TV/VCR TV/VCR TV/VCR
SAT SAT SAT SAT
PIP PIP PIP PIP
DVD DVD DVD DVD
CHAN CHAN CHAN CHAN+ + + +
C C C CH HH HA AA AN N N N
TOGGLE TOGGLE TOGGLE TOGGLE
C C C CC C C C
REPEAT REPEAT REPEAT REPEAT
SUBTITLE SUBTITLE SUBTITLE SUBTITLE SLEEP SLEEP SLEEP SLEEP
INPUT INPUT INPUT INPUT
Programming with Code Search
If your device does not respond after you have tried all
the codes for your brand, or if your brand is not listed,
try searching for your code by following these steps.
1. Manually turn on the device (TV, VCR, etc.) to be
controlled.
2. Press and hold Code Search button until the red
indicator stays on. Release the Code Search button.
3. Press and release the desired mode button (TV, VCR,
etc.). The red indicator blinks, then stays lit.
4. Press the Channel Up button repeatedly (up to 300
times) until the device to be controlled changes
channel. The red indicator blinks, then stays lit. If
you accidentally overshoot the code required, press
the Channel Down button to backtrack through the
library until the device changes channel. Pressing
Channel Up changes direction to forward again.
Press and release Mute to install the code.
The above assumes that you want to store VCR codes
under the VCR button, DVD codes under DVD, etc. If
you want to store a VCR code under DVD, etc., first
follow the procedure on page 10 and try ANY DVD code
from the code tables, e.g. press DVD in step 2, page 10,
and then enter ANY VCR code. Then follow the steps
above.
Note: If the device does not have a Channel Up button,
use Play (VCR only) or Power instead. Code Search
starts from the currently stored three digit number
under that mode.
2.
3. 4.
Direct Code Entry
1. Press and hold the Code Search button until the red
indicator stays on. Release the Code Search button.
2. Press and release the desired mode button (TV, VCR,
etc.).
The red indicator blinks, then stays lit.
3. Enter the 3 digit code from the code tables. Note:
after a valid code entry, the red indicator turns off.
For an invalid code, the red indicator flashes.
4. With your device on, press CHANNEL Up. If the
device responds, no further programming is
required. Note: If some buttons do not operate your
equipment, try one of the other codes for your
brand.
Code Entry
1.
2.
3.
Write your codes down here for easy reference later.
Type Type stored Code
TV TV
VCR
DVD
SAT