beautypg.com

Maintenance, Pump, Engine – Porter-Cable D25805-025-1 User Manual

Page 13

background image

13- ENG

D25805

How To Change Pump Oil

1.

Loosen oil fill cap.

2.

Place a container under the oil drain plug.

3.

Remove oil drain plug.

4.

After oil is drained replace oil drain plug.
Tighten securely.

5.

Remove oil fill cap and fill with
recommended oil. See the Pump Oil Chart
for the correct amount and type of oil.

6. Replace oil fill cap and tighten securely.

MAINTENANCE

WHEN PERFORMING MAINTENANCE, YOU MAY BE
EXPOSED TO HOT SURFACES, WATER PRESSURE, MOVING

PARTS, OR FIRE RESULTING IN SERIOUS INJURY OR DEATH. BEFORE PER-
FORMING ANY MAINTENANCE OR REPAIR, DISCONNECT SPARK PLUG
WIRE, LET ENGINE COOL AND RELEASE ALL WATER PRESSURE. THE
ENGINE CONTAINS FLAMMABLE FUEL. DO NOT SMOKE OR WORK NEAR
OPEN FLAMES WHILE PERFORMING MAINTENANCE.

To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed. If the pressure washer is
used in unusual conditions, such as high-temperatures or dusty conditions, more
frequent maintenance checks will be required.

PUMP

NOTE: The pump was filled with oil at the factory.

1.

Change pump oil after the first ten (10) hours of operation and every fifty (50)
hours thereafter.

CAT

30 W non detergent

*22 oz.

* fill to middle of sightglass

PUMP TYPE

OIL TYPE

OIL CAPACITY

PUMP OIL CHART

ENGINE

Refer to engine manual for the manufacturer’s recommendations for any and all
maintenance.

Oil Fill Plug

Oil Drain Plug

Sight Glass

This manual is related to the following products: