Peavey CS 800S - Manual (Page 31)

MUSIC POWER (IHF-202): (Typical value, 120 VAC, 60 Hz)
Stereo mode, both channels driven, 20 mS burst
2 ohms, 1 kHz, 1% THD: 400 W RMS per channel
4 ohms, 1 kHz, 1% THD: 275 W RMS per channel
8 ohms, 1 kHz, 1% THD: 165 W RMS per channel
Bridge mode, mono:
4 ohms, 1 kHz, 1% THD: 800 W RMS
8 ohms, 1 kHz, 1% THD: 550 W RMS
CONTINUOUS POWER: (Typical value, 120 VAC, 60 Hz)
Stereo mode, both channels driven
2 ohms, 1 kHz, 1% THD: 250 W RMS per channel
4 ohms, 1 kHz, 1% THD: 200 W RMS per channel
8 ohms, 1 kHz, 1% THD: 130 W RMS per channel
Bridge mode, mono:
4 ohms, 1 kHz, 1% THD: 500 W RMS
8 ohms, 1 kHz, 1% THD: 400 W RMS
RATED POWER: (120 V AC, 60 Hz)
Stereo mode, both channels driven
4 ohms, 10 Hz to 20 kHz, 0.03% THD:
190 W RMS per channel
8 ohms, 10 Hz to 20 kHz, 0.02% THD:
120 W RMS per channel
POWER SUPPLY DYNAMIC HEADROOM (IHF-202)
Stereo mode, both channels driven, 20 mSec burst
2 ohms, 1 kHz: +2.04 dB
4 ohms: 1 kHz: +1.38 dB
8 ohms: 1 kHz: +1.04 dB
POWER BANDWIDTH:
Stereo mode, both channels driven
@ rated power, 4 ohms, <0.1% THD: 10 Hz to 50 kHz
TOTAL HARMONIC DISTORTION:
Stereo mode, both channels driven
10 Hz to 20 kHz, 4 ohm @ rated output: Less than 0.03%
HUM and NOISE:
Stereo mode, both channels driven, 30 kHz BW, unweighted
Below rated output power, 4 ohms: Greater than 100 dB
DAMPING FACTOR:
Stereo mode, both channels driven
8 ohms, 100 Hz: Greater than 300
INPUT SENSITIVITY and IMPEDANCE:
Input attenuator set @ FCW
@ rated output power, 4 ohms: 1.0 V RMS (0 dBV),
Phone jack impedance: 20k ohms unbalanced
XLR impedance: 10k ohms per leg, balanced
CHANNEL VOLTAGE GAIN:
Input attenuator set @ FCW
Stereo mode, 4 ohms, 1 kHz: +29 dB
Bridge mode, 8 ohms, 1 kHz: +35 dB
FREQUENCY RESPONSE:
Stereo mode, both channels driven
+0, -1.0 dB @ 1 W RMS, 4 ohms: 3 Hz to 60 kHz
+0, -0.1 dB @ rated output, 4 ohms: 20 Hz to 20 kHz
SLEW RATE:
Stereo mode, each channel: Greater than 40 V/uS
Bridge mode, mono: Greater than 80 V/uS
SQUARE WAVE RESPONSE:
Stereo mode, 4 ohms, 80 V P-P output
100 Hz waveform tilt: Less than 5 volts
10 KHz waveform rise-time: Less than 2 uS, 0% over-shoot
PHASE DISTORTION:
Stereo mode, 4 ohms @ rated power
20 Hz leading waveform: Less than 6 degrees
20 KHz lagging waveform: Less than 15 degrees
POWER CONSUMPTION:
Stereo mode, both channels driven
@ rated output power, 4 ohms: 5 A @ 120 VAC
COOLING SYSTEM:
Dual continuously variable speed DC fans
DDT ª COMPRESSION SYSTEM:
Automatic, switchable with LED indicator
DIMENSIONS and WEIGHT:
Height: 3.75" (9.53 cm)
Width: 19" (48.3 cm)
Depth: 16.88" (42.88 cm)
Weight: 30.3 lbs. (13.74 kg)
CS ¨ 500A SPECIFICATIONS
Specifications subject to change without notice.
31