Pioneer PDK-FS05 - Manual (Page 12)

12
En
4
Attach plasma display to support legs.
Fit the stand’s support columns to the bottom of the plasma display
as indicated by the arrows, then slowly insert them vertically. Be
extremely careful not to insert the support legs of the stand into
any part of the plasma display other than the stand insertion slots.
Note that doing so might damage the plasma display panel or its
ports or result in the warping of the stand. If the plasma display is
fitted with handles, it is usually best to hold the display by its
handles when attaching it to the support legs.
Be sure to work with at least one other person
when attaching the display.
Be careful not to allow your fingers get caught
between the display and support legs.
If the PDP bracket has been placed into the upper
bracket holes and speakers are to be installed
below the plasma display or one body type
plasma display, care must be taken to ensure that
the display is firmly supported as its position will
be higher.
5
Use the middle or the long hexagonal bolts to fix
the plasma display to the support legs (4 locations).
Please install starting with the bolts on the top.
When installing the PDP-506XDE / PDP-506FDE / PDP-
506HDG / PDP-436XDE / PDP-436FDE / PDP-436HDG
Use the following bolts to fix it with the hexagonal wrench.
Top .................. Middle hexagonal bolts (M8 x 35 mm: black)
Bottom ............ Middle hexagonal bolts (M8 x 35 mm: black)
Middle hexagonal bolts
(M8 x 35 mm: black)
If speakers are to be installed at the sides or the bottom of
the plasma display, they should be attached at this phase.
See the installation instructions provided with your
speakers for instructions on how to install them.
Caution
B When installing speakers below the plasma display
or one body type plasma display
Use the long support legs.
Use the hexagonal wrench included with the stand to do so.
Caution
The types of plasma displays which may be used
with the stand differ depending on the length of
the support legs attached to the PDP bracket, so
you should check to see if the display to be
attached is compatible before proceeding.
Long support legs
Long support
legs
Slide grooves
into place
PDP bracket
Short hexagonal bolts
(M8
× 16 mm: black)
Installation and assembly instructions
Line up the support legs
with the bottom of the
plasma display as
indicated in the
accompanying diagram.
Middle hexagonal bolts
(M8 x 35 mm: black)
Middle hexagonal bolts
(M8 x 35 mm: black)
When installing the one body type plasma display
Use the following bolts to fix it with the hexagonal wrench.
Top .................. Long hexagonal bolts (M8 x 60 mm: silver)
Bottom ............ Middle hexagonal bolts (M8 x 35 mm: black)
Long hexagonal bolts
(M8 x 60 mm: silver)