ProForm PFTL73105.1 User Manual

Page 7

4. Press the Latch Housing (73) into the left Upright (84).

Tap the Latch Housing with a rubber mallet if necessary.

Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Next, insert
the pin into the Latch Housing (73). Then, tighten the
knob back onto the pin.

Spring

Collar

Knob

3. Insert the Wire Harnesses (77, 78) down into the right

Upright (84).

Set the console assembly on the Uprights (84).

Be care-

ful to avoid pinching the Wire Harnesses (77, 78).
Whilst a second person holds the console assembly, at-
tach it with four Console Bolts (64) and four Star Washers
(8) as shown;

start all four Console Bolts and then

firmly tighten them.

Console

Assembly

77, 78

2. With the help of a second person, carefully raise the

Uprights (84) to a vertical position.

Have the second person hold the console assembly near
the Uprights (84) as shown. Look under the console as-
sembly and locate the Console Wire Harness (78).

Cut the plastic ties securing the Upright Wire Harness
(77) to the right Upright (84). Next, connect the Upright
Wire Harness to the Console Wire Harness (78).

Make

sure to connect the connectors properly (see the
inset drawing). The connectors should slide together
easily and snap into place. If the connectors do not
slide together easily and snap into place, turn one con-
nector and then try again.

IF THE CONNECTORS ARE

NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.

Console

Assembly