Pioneer DVH-P4100UB - Manual (Page 58)

7 Plug the microphone into the micro-
phone input jack on the multi-channel pro-
cessor.
8 Press MULTI-CONTROL to start the auto
TA and EQ.
9 Get out of the car and close the door
within 10 seconds when the 10-second
count-down starts.
The measurement tone (noise) is outputted
from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ is completed in about nine minutes.
# To stop auto TA and EQ, press any keys.
# To cancel auto TA and EQ part way through,
press
BAND/ESC.
10 When auto TA and EQ is completed,
COMPLETE is displayed.
When correct measurement of car interior
acoustic characteristics is not possible, an
error message is displayed. (Refer to Under-
standing auto TA and EQ error messages on
page 67.)
11 Press BAND/ESC to cancel the auto TA
and EQ mode.
12 Store the microphone carefully in the
glove compartment.
Store the microphone carefully in the glove
compartment or any other safe place. If the
microphone is subjected to direct sunlight for
an extended period, high temperatures may
cause distortion, color change or malfunction.
Setting the speaker setting
You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to
LRG (large) if
the speaker is capable of reproducing sounds
of about 100 Hz or below. Otherwise select
SML (small).
! Low frequency range is not output if the
subwoofer is set to OFF and the front and
rear speakers set to SML or OFF.
! It is imperative that non-installed speakers
be set to OFF.
! Set the front or rear speaker to LRG if the
speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1 Use MULTI-CONTROL to select FRONT
(speaker setting) in the audio function
menu.
Refer to Introduction of DSP adjustments on
page 52.
2 Press c or d to select the speaker to be
adjusted.
FRONT (front speakers)
—CENTER (center
speaker)
—REAR (rear speakers)—SUB.W
(subwoofer)
—PHASE (subwoofer setting)
# You can switch to PHASE only when the sub-
woofer has been set to
ON.
3 Press a or b to select the correct size
for the selected speaker.
OFF (off)
—SML (small)—LRG (large)
# You cannot select OFF, when FRONT (front
speakers) have been selected.
# You can select ON or OFF, when SUB.W (sub-
woofer) has been selected.
# You can switch REV (reverse phase) or NOR
(normal phase), when
PHASE (subwoofer setting)
has been selected.
Available accessories
En
58
Section
03