Warning – Poulan Pro PPB1000E User Manual

Page 3

Always wear heavy, long pants, long sleeves,

boots, and gloves.

Always wear foot protection. Do not go bare-

foot or wear sandals.

Secure hair above shoulder length. Secure

or remove loose clothing or clothing with

loosely hanging ties, straps, tassels, etc.

They can be caught in moving parts.

Being fully covered also helps protect you

from debris and pieces of toxic plants thrown

by spinning blade.

Stay alert. Do not operate when you are tired,

ill, upset, or under the influence of alcohol,

drugs, or medication. Watch what you are do-

ing; use common sense.

Wear hearing protection.

Never start or run inside a closed room or

building. Breathing exhaust fumes can kill.

Keep handles free of oil and fuel.

Keep hands and feet away from cutting area.

Never direct discharge of material toward by-

standers nor allow anyone near the area of

operation. Use care in directing discharge to

avoid glass enclosures, automobiles, and the

like.

FUEL SAFETY (for gas powerheads)

Mix and pour fuel outdoors.

Keep away from sparks or flames.

Use a container approved for fuel.

Do not smoke or allow smoking near fuel or

the powerhead.

Avoid spilling fuel or oil. Wipe up all fuel spills

before starting the powerhead.

Move at least 10 feet (3 meters) away from

fueling site before starting powerhead engine.

Stop engine and allow to cool before remov-

ing fuel cap.

Remove fuel cap slowly.

ELECTRICAL SAFETY (for electric

powerheads)

WARNING:

Avoid a dangerous envi-

ronment. To reduce the risk of electrical shock,

do not use in rain, in damp or wet locations, or

around swimming pools, hot tubs, etc. Do not

expose to snow, rain, or water to avoid the pos-

sibility of electrical shock. Do not use on wet

surfaces. Do not handle extension cord plug or

unit with wet hands.
S

Use only a voltage supply as shown on the

nameplate of the unit.

Avoid dangerous situations. Do not use in

presence of flammable liquids or gases to

avoid creating a fire or explosion and/or

causing damage to unit.

Avoid dangerous environments. Do not use

in unventilated areas or where dust or ex-

plosive vapors can build up.

To reduce the risk of electric shock, the

powerhead may have a polarized plug (one

blade is wider than the other); if so, it will re-

quire the use of a polarized extension cord.

The appliance plug will fit into a polarized

extension cord only one way. If the plug

does not fit fully into the extension cord, re-

verse the plug. If the plug still does not fit,

obtain a correct polarized extension cord.

A polarized extension cord will require the

use of a polarized wall outlet. This plug will

fit into the polarized wall outlet only one

way. If plug does not fit fully into the wall

outlet, reverse the plug. If it still does not fit,

contact a qualified electrician to install the

proper wall outlet. Do not change the equip-

ment plug, extension cord receptacle, or

extension cord plug in any way.

To reduce risk of electrical shock, use ex-

tension cords specifically marked as suit-

able for outdoor appliances having electri-

cal rating not less than the rating of unit.

Cord must be marked with suffix “W--A” (in

Canada “W”). Make sure your extension

cord is in good condition. Inspect extension

cord before use and replace if damaged. Do

not use a damaged cord. Cord insulation

must be intact with no cracks or deteriora-

tion. Plug connectors must be undamaged.

The extension cord used to reach the pow-

er source must be heavy enough to carry

current from the power source the full length

of the extension cord to the unit. An under-

sized extension cord will cause a drop in

line voltage resulting in loss of power and

overheating. If in doubt, use the next heavi-

er gauge. The lower the gauge number, the

heavier the cord.

Do not use multiple cords.

Do not abuse cord. Never carry the unit by

the extension cord or yank extension cord

to disconnect unit. To unplug, grasp the

plug, not the cord. Do not use cord as a han-

dle, close a door on cord, or pull cord

around sharp edges or corners. Do not ex-

pose cords to heat, oil, or water.

Keep the extension cord clear of operator and

obstacles at all times. Tie cord to cord retain-

er and connect to recessed plug as shown

in this manual to prevent damage to unit

and/or extension cord and to reduce the

possibility of the extension cord discon-

necting from the unit during operation.

Do not attempt to repair unit. Inspect the insu-

lation and connectors on the powerhead and

extension cord before each use. If there is

any damage, do not use until damage is re-

paired by your authorized service dealer.

Do not use the powerhead if the switch

does not turn the unit on and off properly.

Have the unit repaired by your authorized

service dealer.

Do not use with damaged cord or plug. If

powerhead is not working as it should, has

been dropped, damaged, left outdoors, or

dropped into water, return it to your autho-

rized service dealer for repair.

Avoid unintentional starting of the unit. Nev-

er carry unit with your finger on the switch.

Be sure the switch is in the OFF position

and never touch the switch when connect-

ing extension cord.

Unplug the unit from the power source when

not in use, before servicing, and when chang-

ing accessories and/or attachments.

Avoid any body contact with any grounded

conductor, such as metal fences, or pipes,

to avoid the possibility of electric shock.