beautypg.com

Connecting the mixer outputs, Using headphones, Connecting the lamp – PYLE Audio PYD3808 User Manual

Page 5: Output to an amplifier, Output to a tape or digital audio recorder, Booth output

background image

Tape Deck
Amplifier/Receiver

OFF
OFF

FLAT

0

0

CENTER

OUTPUT DEVICE

SETTING

CONTROL

POWER
POWER

TONE

CAUTION: In order to avoid sudden unpleasant sound output,

adjust the output devices controls to these settings before you

connect the mixer’s output jacks to these devices’ input jacks.

Pyle Pro Mixer Owner’s Manual – 7

6 – Pyle Pro Mixer Owner’s Manual

Output to an Amplifier

To play the mixer’s output signal through your speaker system (for events such as parties, dances,

conferences, etc.) connect an audio patch cord (not supplied) from the mixers AMP L and R jacks

to your receiver amplifier’s left and right input jacks.

This mixer features two kinds of output jacks for you to choose from: RCA style and 1/4” type. DO

NOT USE BOTH SIMULTANEOUSLY.

Connecting the Mixer Outputs

Output to a Tape or Digital Audio Recorder

To play the mixer’s output signal through your speaker system (for events such as parties, dances,

conferences, etc.) connect an audio patch cord (not supplied) from the mixers REC L and R jacks

to your receiver/amplifier’s left and right input jacks.

Booth Output

To monitor the mixer output to a second set of speakers in the DJ booth (or in a remote location)

connect an audio patch cord (not supplied) from the mixers Booth L and R jacks to your secondary

amplifier’s left and right input jacks.

Plug a pair of stereo headphones (not supplied) with a 1/4” jack into the Phones input. Using

headphones not only affords you the opportunity to listen privately, but also enables you to monitor

(”cue”) the incoming audio sources so you can locate an exact passage or section before mixing it

in. It also gives you the opportunity to set up the relative volume level of the upcoming passage

before it joins the mix.

Using Headphones

Do not listen at extremely high volume levels. Extended,

high-volume listening can lead to permanent hearing loss.

Follow these guidelines to protect your hearing, especially

when using headphones.

Always start by setting the volume level to the lowest

possible level before listening.

Put headphones on, and then gradually increase the

volume as necessary.

Once you set the volume level do not increase it. Over

a period of time, your ears adapt to a volume level and there

is a temptation to increase it. Even though such an increase

may not cause discomfort, it might still damage your hearing.

Listen Safely! Please observe the following:

12V/3W lamp

Stereo Headphones

If you wish to intall a console lamp (not supplied), simply insert the plug end of an appropriate

12V/3W gooseneck style or similar lamp into the lamp socket provided in the upper right corner of

the mixer control panel. Power is supplied to this lamp when the mixer power switch is turned on.

Connecting the Lamp

This manual is related to the following products: