Porter-Cable A07708-0412-0 - Manual (Page 12)

12- ENG A07708
MAINTENANCE
When performing
maintenance, you
may be exposed to hot surfaces,
water pressure, or moving parts
that can cause serious injury or
death!
Before performing any maintenance
or repair, disconnect spark plug
wire, let engine cool and release
all water pressure. The engine
contains flammable fuel. DO NOT
smoke or work near open flames
while performing maintenance.
To ensure efficient operation and
longer life of your pressure washer,
a routine maintenance schedule
should be prepared and followed.
If the pressure washer is used in
unusual conditions, such as high-
temperatures or dusty conditions,
more frequent maintenance checks
will be required.
ENGINE
Consult the Engine Owners
Manual for the manufacturer's
recommendations for any and all
maintenance. NOTE: The frame is
equipped with an oil drain hole to help
make changing the engine oil easier.
PUMP
NOTE: The pump was filled with oil at
the factory.
1. Change pump oil after the first ten
(10) hours of operation and every
fifty (50) hours thereafter.
To Check Oil:
1. The oil level should come to the
red dot in the middle of the sight
glass.
How To Change Pump Oil
1. Loosen oil fill plug.
2. Place a container under the oil
drain plug.
3. Remove oil drain plug.
4. After oil is drained replace oil
drain plug. Tighten securely.
5. Remove oil fill plug and fill to the red
dot in the middle of the sight glass
with 30W non detergent oil.
6. Replace oil fill plug and tighten
securely.
Oil Drain Plug
Sight
Glass
Oil fill Plug